H4895 60% Load

[RL338]

Questions for those who have use this.
How clean does it burn?
How is the ES?
Accuracy?
Muzzle flash?
I have a project that I’m working on with my 458WM. I’ve use a lot of Blue Dot and 5744 both of which are hard to find.
Any feedback will appreciated.

Thanks , Rick

 

[TackDriver284]

I have used H4895 for my .308 using the 150 Ballistic Tips, it was so accurate, burns clean, single digit ES / SD and temp stable. I have used full power and reduced loads without any issues.

 

[Slimfinn]

I loaded reduced 260rem loads when my daughter was small and it was the most accurate load I've ever had in that rifle

 

[RL338]

Good to hear , and thanks guys. H4895 is available locally.
The original plan was to run the Hornady 410gr subsonic with TrailBoss. That plan fell apart , now I’m looking to run them around 1500-1600fps.

 

[FNWhelen]

I used H4895 at about 70% in a 30-06 Tika. I made the loads with 130 grain bullets. My reason was so those who wanted to shoot a larger round but not get beat up could ring steel at 100 and 200 yards. I have not run the loads over my chronograph but I have a four shot group my wife shot at 100 and all four holes are touching so it must be a pretty good load. After that I just just about out of H4895 and could not find any around here. A few months later I got very lucky and found a new 8 pound jug for $250 at a local gun show.

 

[jimbires]

I've worked with H4895 in reduced loads a fair amount . I doubt if I ever checked ES , or SD numbers with it seeing as these would be 200 yard max ammo . I never seen a problem using it . didn't seem dirty . wasn't position sensitive . no hang fires . it just worked well , for me . accuracy was usually pretty good . if your interested , you should be able to search this forum , and find some of my reduced load work , I posted a lot of it .

 

[wvbuckbuster]

I used it for a reduced load in my 223 for squirrels and turkeys. No issues.