I've wanted a hot 6mm for along time and I finally got a Savage barrel wrench(not common here in Canada), so I am wondering what could I expect from a 6mm WSM?? I am of the mind I can get 3200 with a 105-107 grn match bullet and around 3050-3100 with a 115 grn DTAC, but am not sure that is worth the extra case prep and dies.
If I go 6mm WSM AI then I need dies, reamer and HS guages as well.
The 243 AI gets close to the 6mm WSM, so how much improvement would the 6mm AI in 40 or 44 degree offer?
Barrel considered is a 3 groove 8 twist Pac-nor 29" no taper, full OD cylinder in case I don't like this chambering I can recut and setback threads a couple times.
If it can't launch a 115 DTAC over 3250 I'd think it to be a waste of time for the effort and money required.
JT.
If I go 6mm WSM AI then I need dies, reamer and HS guages as well.
The 243 AI gets close to the 6mm WSM, so how much improvement would the 6mm AI in 40 or 44 degree offer?
Barrel considered is a 3 groove 8 twist Pac-nor 29" no taper, full OD cylinder in case I don't like this chambering I can recut and setback threads a couple times.
If it can't launch a 115 DTAC over 3250 I'd think it to be a waste of time for the effort and money required.
JT.