hunter1276
Beginner
- Jan 24, 2012
- 63
- 0
ok i loaded varmagedon with ram shot 24,25,26 grain uhhh cci primer, rem. brass. and uh WOW i got savage put together after paint job used some FMJ i had to check and zero it in. no problem then shot in 3min. intervals 24 grain they smack same holes. went to 25gr. same shooting blam a lil dead center all touching. went to 26 same deal lil high dead center all touching. check cases along way to check for over pressure,nothing. so question is since they all are TIGHT as (insert favorite phrase) then would it just be a matter of how fast i want it to go and how much powder i wanna burn? it was at 100 yrd. will try 200 and 300 later. and see how it goes.
