QL for 243 Win

EOD Diver

Handloader
Dec 30, 2011
593
184
Howdy Guys,
Hope all is well in your neck of the woods this Christmas season! I was hoping someone might be able to help me out with a QL projection for the following:

243 Win (Nosler cases)
22” barrel length
90 grain AccuBond bullets
RL 26 powder running up to 64K for a max

I know RL 26 will probably be a touch slow, but it’s all I’ve got at the moment. Appreciate the assist!

V/R,

Joe
 
Code:
Cartridge          : .243 Win.
Bullet             : .243, 90, Nosler Accubond 56357
Useable Case Capaci: 48.885 grain H2O = 3.174 cm³
Cartridge O.A.L. L6: 2.710 inch = 68.83 mm
Barrel Length      : 22.0 inch = 558.8 mm
Powder             : Alliant Reloder-26

Predicted data by increasing and decreasing the given charge,
incremented in steps of 1.0% of nominal charge.
CAUTION: Figures exceed maximum and minimum recommended loads !

Step    Fill. Charge   Vel.  Energy   Pmax   Pmuz  Prop.Burnt B_Time
 %       %    Grains   fps   ft.lbs    psi    psi      %        ms

-10.0   94    45.36   2902    1683   42437  12461     97.6    1.245
-09.0   95    45.86   2940    1727   44105  12583     98.0    1.223
-08.0   96    46.37   2977    1772   45836  12696     98.5    1.201
-07.0   97    46.87   3015    1817   47669  12798     98.8    1.179
-06.0   98    47.38   3052    1862   49572  12891     99.2    1.158
-05.0   99    47.88   3090    1908   51564  12973     99.4    1.137
-04.0  100    48.38   3127    1954   53650  13044     99.7    1.117
-03.0  101    48.89   3164    2001   55833  13104     99.8    1.097  ! Near Maximum !
-02.0  102    49.39   3201    2048   58119  13153     99.9    1.078  ! Near Maximum !
-01.0  103    49.90   3238    2095   60515  13190    100.0    1.058  ! Near Maximum !
+00.0  104    50.40   3274    2143   63025  13217    100.0    1.039  ! Near Maximum !
+01.0  105    50.90   3311    2190   65661  13241    100.0    1.021  !DANGEROUS LOAD-DO NOT USE!
+02.0  106    51.41   3347    2238   68425  13264    100.0    1.002  !DANGEROUS LOAD-DO NOT USE!
+03.0  107    51.91   3383    2287   71330  13285    100.0    0.984  !DANGEROUS LOAD-DO NOT USE!
+04.0  108    52.42   3418    2335   74381  13304    100.0    0.967  !DANGEROUS LOAD-DO NOT USE!
+05.0  109    52.92   3454    2384   77573  13323    100.0    0.950  !DANGEROUS LOAD-DO NOT USE!

Results caused by ± 10% powder lot-to-lot burning rate variation using nominal charge
Data for burning rate increased by 10% relative to nominal value:
+Ba    104    50.40   3435    2358   80072  12617    100.0    0.946  !DANGEROUS LOAD-DO NOT USE!
Data for burning rate decreased by 10% relative to nominal value:
-Ba    104    50.40   3029    1833   48729  13333     96.1    1.162
 
Joe, RL26 and 90 Accubonds are amazing in my little brothers 243. I worked them up last year and he has been killing all sorts of deer with it. He even mentioned it has put deer down faster than the 120 Partition in his 257 Weatherby I load for him as well. That's saying something right there.

Plenty of room in the case for 26 and the speeds attained are amazing.
 
Scotty,
I’m really pumped to give it a go! It took a spell to get the components squared away, but I think I’m ready to make it happen. The 90 grain ABs at 3250 should make for a dandy rifle for deer or the kiddos and hearing your results with the combo is music to my ears.
V/R,
Joe
 
I’m afraid not just yet. I went TAD for a spell and am way behind the power curve since returning. I did manage to pick up some 55gr BTs for the 243 though. I’d like to run them as light as I safely can, but I’ve got a little carpentry to do on the rifle first. The LOP is way too much on it as it stands.
V/R,
Joe
 
Back
Top