Notice: This site is not mobile friendly, we recommend you download tapatalk for a mobile friendly experience of our forum.

It is currently Tue Jul 16, 2019 2:12 pm

Shop Nosler

All times are UTC - 8 hours [ DST ]




Post new topic Reply to topic  [ 8 posts ] 
Author Message
 Post subject: Sako 180gr Super Hammerhead
PostPosted: Tue Jun 04, 2019 12:07 pm 

Joined: Sat Feb 11, 2017 2:22 pm
Posts: 231
Ordered some Sako Super Hammerhead in 30-06 to test out and see if it would work for elk and moose. I've only shot half a box so far and am still evaluating everything, but it seems to be decent ammo.

I mainly reload, but in the last year or so I've learned that some times it's not bad to have some factory ammo on the shelf for back up. Some publications started that Sako brass was top notch so no matter what I'd at least have some decent brass while seasoning a new 30-06 barrel.

Straight from Sako's website:

"A heavy jacketed, strong and non-fragmenting bullet that ensures controlled expansion. A bonded core provides high weight retention, which results in effective penetration. It is boat-tailed for high ballistic efficiency, which causes a flatter trajectory. It was developed and tested by Sako ballistic laboratories first, followed by actual extensive big game hunting tests. The bullet is designed for big game hunting at short to medium distances."

Fired a 3 shot group at 100 yards today, from a bench with front and rear bags, it was exactly an inch. Touched off another 3 shots at the same target about 15 minutes later, this one was half an inch, inside the first group. First shot I took with the ammo was the only one outside of the six rounds fired, still getting used to the rifle I suppose. Great shooting ammo at 100 yards.

Finally fired one round into milk jugs. This was where things got interesting. I had 7 jugs lined up at 100 yards, hit them dead center. Packed up my gear and went to see the damage done. First milk jug was literally turned inside out. Next two were destroyed beyond recognition. Jugs four and five were perforated in an nice straight line, still standing on the 2x6. Jug six held my slug, when I went to dump it out two pieces plopped out into my hand. The core separated from the case, making me question their bonding methods. Jacket had opened up nicely to the cannular.

Retained weight was 125.7gr from the starting 180. If it shoots well to 300 I'll be fine with it, but I was more than surprised to see the separation of the lead.

Here are photos of the retained slug and the first milk jug.



ImageImageImageImage

Sent from my SM-G960U using Tapatalk


Top
Offline Profile  
Reply with quote  
 Post subject: Re: Sako 180gr Super Hammerhead
PostPosted: Tue Jun 04, 2019 12:11 pm 

Joined: Sun Dec 24, 2006 12:20 pm
Posts: 29138
Location: Northern Virginia
It looks like a good Bullet to me. Plenty tough for deer and elk. Looks like a heavy jacket on it.

_________________
SEMPER FIDELIS

Actually, there are only two classes of people posting here: Model 70 owners and those who wish they had one. PATENT PENDING


Top
Offline Profile  
Reply with quote  
 Post subject: Re: Sako 180gr Super Hammerhead
PostPosted: Tue Jun 04, 2019 1:13 pm 

Joined: Wed Nov 08, 2006 2:49 pm
Posts: 32069
Location: Northern British Columbia
It will work, and work well, I should imagine. I do agree that the claim for bonding would be challenged on the basis of the one recovered bullet. It will be interesting to see how they stand up to game.

_________________
Fortiorum fortia facta


Top
Offline Profile  
Reply with quote  
 Post subject: Re: Sako 180gr Super Hammerhead
PostPosted: Wed Jun 05, 2019 6:11 am 

Joined: Sat Feb 11, 2017 2:22 pm
Posts: 231
I have tested other bullets that veer off a straight path often, so that was nice to see it penetrate deep and straight. It shot well enough that for a dollar a round I did order another 6 boxes from Beretta. I'm going to shoot it again into jugs but with some form of barrier in front of the first jug this time. I have ten pieces of brass now, so I going to get to measuring brass next.

Over all, slightly disappointed that the jacket separated but I won't let the sample of one overshadow great results in target and in the jugs.

Sent from my SM-G960U using Tapatalk


Top
Offline Profile  
Reply with quote  
 Post subject: Re: Sako 180gr Super Hammerhead
PostPosted: Wed Jun 05, 2019 8:50 am 

Joined: Mon Aug 14, 2017 8:11 am
Posts: 46
I have been shooting the SAKO Super-hammerhead in my SAKO 85 for a couple of years. I have found them to be very accurate and give good velocity. I have been getting 1 to 3/4 in groups with 2710 fps out of a 22 inch barrel. I use the brass for reloading some of my 06 loads and see about 30 fps increase over the same load using Winchester brass. Overall I think the ammo is excellent.


Top
Offline Profile  
Reply with quote  
 Post subject: Re: Sako 180gr Super Hammerhead
PostPosted: Wed Jun 05, 2019 9:16 pm 

Joined: Wed Nov 28, 2018 8:39 am
Posts: 89
Location: SW Montana
I bought a couple boxes of the 180 and a bunch of the 150s . Mostly been shooting the 150s and they group very nice. Here is 3 2 shot groups i did just to compare trajectory @100yds so point of aim was the same for all, off bags on a bench. top sako superhammer 150gr, middle fed prem 165 nosler AB, and bottom sako superhammer 180.
I have no complaints with the accuracy of Sako ammo in the 3 cartridges I've tried 243,260,30-06.


Attachments:
15597942851573806999448354511757.jpg
15597942851573806999448354511757.jpg [ 1.68 MiB | Viewed 262 times ]
Top
Offline Profile  
Reply with quote  
 Post subject: Re: Sako 180gr Super Hammerhead
PostPosted: Sun Jun 23, 2019 6:07 am 
User avatar

Joined: Sat Dec 03, 2011 5:13 pm
Posts: 157
Location: Central Florida
I tested some 250's in my 338 and posted results here : viewtopic.php?f=52&t=29600


Top
Offline Profile  
Reply with quote  
 Post subject: Re: Sako 180gr Super Hammerhead
PostPosted: Mon Jun 24, 2019 11:03 am 

Joined: Sat Feb 11, 2017 2:22 pm
Posts: 231
So I ran the 180s through my Mag Speed today. Tight chambers produce crazy velocities.

4 shots, average of 2891fps, es 11, SD 4.3.

Lines up with my testing of RL22 and 180gr Partitions. I stopped at 60gr with a velocity of 2899, two grains under max per Nosler. Pulled the rest of my rounds.

Sent from my SM-G960U using Tapatalk


Top
Offline Profile  
Reply with quote  
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 8 posts ]  Moderators: JD338, NOSLER, FOTIS, NoslerV, Nosler4

All times are UTC - 8 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  

This forum is:

Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
Theme created StylerBB.net