Powerstroke
Handloader
- Feb 24, 2006
- 1,799
- 60
I've been on the fence of trading or getting rid of my Rem 700 VTR in .223 since I've not seen the results that I would like.
One of the biggest reasons I purchased the VTR was because of the 1:9 twist in a bolt action rifle - hopefully would allow me to shoot the 70gr VLD's.....
Well, after having the bolt issue resolved now with sako extractor and bushed firing pin I'm starting to get too deep into it to trade.... maybe I'm expecting too much from it, but IMO it should shoot 3/4in or preferably better.
I've shot 70gr VLD's, 60, 55, 50, 40gr B-tips, 55gr B-kings & 52gr SMK's The 52gr SMK's were my last resort, as I figured no matter the case, I could get them to shoot.
So far, my best luck has been with the 60gr BT's - The rifle will group two or three basically cutting the same hole and then throw one an inch out. In all fairness, I did attempt to bed the plastic fantastic stock, as the barrel was hanging to the left side really hard - the bedding job / sanding a lot has not done real well on getting the barrel off the side of the stock and keeping the cosmetics good.
With all that said, I purchased a Leupy Mark AR 6 X 18 yesterday for it, and soon to place it in a B&C light tactical stock.
Question is - what load recomendations are out there for the heavier bullets ? I really dont' want to use any under 55gr, I have nosler brass ready to go :grin:
CCI BR primers - powders on hand ( N-140, Varget, IMR 3031, BLC-2, H335, H332, W748, A lot of IMR 4198 that is older and not real sure what we used it for )
Thougts and recomendations greatly appreciated - It's time to go coyote hunting ! :lol:
One of the biggest reasons I purchased the VTR was because of the 1:9 twist in a bolt action rifle - hopefully would allow me to shoot the 70gr VLD's.....
Well, after having the bolt issue resolved now with sako extractor and bushed firing pin I'm starting to get too deep into it to trade.... maybe I'm expecting too much from it, but IMO it should shoot 3/4in or preferably better.
I've shot 70gr VLD's, 60, 55, 50, 40gr B-tips, 55gr B-kings & 52gr SMK's The 52gr SMK's were my last resort, as I figured no matter the case, I could get them to shoot.
So far, my best luck has been with the 60gr BT's - The rifle will group two or three basically cutting the same hole and then throw one an inch out. In all fairness, I did attempt to bed the plastic fantastic stock, as the barrel was hanging to the left side really hard - the bedding job / sanding a lot has not done real well on getting the barrel off the side of the stock and keeping the cosmetics good.
With all that said, I purchased a Leupy Mark AR 6 X 18 yesterday for it, and soon to place it in a B&C light tactical stock.
Question is - what load recomendations are out there for the heavier bullets ? I really dont' want to use any under 55gr, I have nosler brass ready to go :grin:
CCI BR primers - powders on hand ( N-140, Varget, IMR 3031, BLC-2, H335, H332, W748, A lot of IMR 4198 that is older and not real sure what we used it for )
Thougts and recomendations greatly appreciated - It's time to go coyote hunting ! :lol: