Not sure what rifle you have, but here is some data at 52K PSI.. If you let me know the H20 capacity of your cases and the rifle, we can tune the data a little.
Cartridge : .250 Ack Imp (250 Savage)
Bullet : .257, 75, Hornady V-MAX 22520
Useable Case Capaci: 50.176 grain H2O = 3.258 cm³
Cartridge O.A.L. L6: 2.710 inch = 68.83 mm
Barrel Length : 25.0 inch = 635.0 mm
Powder : Hodgdon CFE223
Predicted data by increasing and decreasing the given charge,
incremented in steps of 2.0% of nominal charge.
CAUTION: Figures exceed maximum and minimum recommended loads !
Step Fill. Charge Vel. Energy Pmax Pmuz Prop.Burnt B_Time
% % Grains fps ft.lbs psi psi % ms
Results caused by ± 10% powder lot-to-lot burning rate variation using nominal charge
Data for burning rate increased by 10% relative to nominal value:
+Ba 89 46.00 3685 2262 61762 9447 100.0 0.962 !DANGEROUS LOAD-DO NOT USE!
Data for burning rate decreased by 10% relative to nominal value:
-Ba 89 46.00 3284 1797 41698 9234 91.5 1.140
Cartridge : .250 Ack Imp (250 Savage)
Bullet : .257, 85, Nosler BalTip 43004
Useable Case Capaci: 48.487 grain H2O = 3.148 cm³
Cartridge O.A.L. L6: 2.710 inch = 68.83 mm
Barrel Length : 25.0 inch = 635.0 mm
Powder : Hodgdon CFE223
Predicted data by increasing and decreasing the given charge,
incremented in steps of 2.0% of nominal charge.
CAUTION: Figures exceed maximum and minimum recommended loads !
Step Fill. Charge Vel. Energy Pmax Pmuz Prop.Burnt B_Time
% % Grains fps ft.lbs psi psi % ms