Jimbeaux82
Handloader
- Jan 6, 2011
- 416
- 196
Can 300 Sav cases be made by running a 308 Win case thru a 300 Savage die and then trimming down to proper length? Or is it better to sue another case?
300 Sav from 308
- Thread starter Jimbeaux82
- Start date
I suggest doing a search for savage 300 brass. It appears it can be had. From what I can read you can form it from .308 brass. Here again I seggest a search, however I like to have properly headstamped brass if I can. I have several wildcats and cannot always do this.
It should be possible, but I tried it once and had no luck feeding them. I think you're better off getting some from Midway. They aren't always available, but Win and Rem do a seasonal run of them and they usually show up by April. If you were going to try to make them, I would use a 7mm08 to decrease the likelihood that any of your ammo could accidentally be loaded in a 308 win which could be dangerous.
- Nov 4, 2004
- 27,127
- 13,632
I would just get 300 Savage and have the proper head stamp on the brass.
JD338
JD338
- Thread starter
- #5
Jimbeaux82
Handloader
- Jan 6, 2011
- 416
- 196
Yes - probably best to get the right headstamped brass, just have a bunch of 308 brass and no 308 rifle at the moment.
Whenever I do use a different headstamped brass by reforming, I try to use nickle cases so that it stands out as something different and not normally something I reload.
Whenever I do use a different headstamped brass by reforming, I try to use nickle cases so that it stands out as something different and not normally something I reload.
Yeah, it can be done, but you will have issues to contend with... the previously mentioned improper headstamps, and more than likely your necks will be too think and will need to be turned/reamed. Who knows what capacity will be, so you might have too-high pressures if the parent brass is thicker.
