I finally got my dies, bullets and brass to load for my 7mm Rem Mag. I have some Ramshot Hunter I would like to try but I am not sure where the max charge should be with the E-tips.
Can anybody point me in the right direction?
Cartridge : 7 mm Rem. Mag.
Bullet : .284, 140, Nosler E-Tip 59955
Useable Case Capaci: 73.225 grain H2O = 4.754 cm³
Cartridge O.A.L. L6: 3.290 inch = 83.57 mm
Barrel Length : 24.0 inch = 609.6 mm
Powder : Ramshot Hunter
Predicted data by increasing and decreasing the given charge,
incremented in steps of 2.0% of nominal charge.
CAUTION: Figures exceed maximum and minimum recommended loads !
Step Fill. Charge Vel. Energy Pmax Pmuz Prop.Burnt B_Time
% % Grains fps ft.lbs psi psi % ms
Yes, the .300 AAC Blackout is available. What bullet and powder you thinking of using? Here's a sample:
Cartridge : .300 AAC Blackout
Bullet : .308, 168, Nosler CC HPBT J4 53164
Useable Case Capaci: 20.405 grain H2O = 1.325 cm³
Cartridge O.A.L. L6: 2.260 inch = 57.40 mm
Barrel Length : 18.0 inch = 457.2 mm
Powder : Alliant Reloder- 7
Predicted data by increasing and decreasing the given charge,
incremented in steps of 2.0% of nominal charge.
CAUTION: Figures exceed maximum and minimum recommended loads !
Step Fill. Charge Vel. Energy Pmax Pmuz Prop.Burnt B_Time
% % Grains fps ft.lbs psi psi % ms
Cartridge : .300 AAC Blackout
Bullet : .308, 168, Nosler CC HPBT J4 53164
Useable Case Capaci: 20.405 grain H2O = 1.325 cm³
Cartridge O.A.L. L6: 2.260 inch = 57.40 mm
Barrel Length : 18.0 inch = 457.2 mm
Powder : Accurate 1680
Predicted data by increasing and decreasing the given charge,
incremented in steps of 2.0% of nominal charge.
CAUTION: Figures exceed maximum and minimum recommended loads !
Step Fill. Charge Vel. Energy Pmax Pmuz Prop.Burnt B_Time
% % Grains fps ft.lbs psi psi % ms