Need the benefit of Some ones "quick load". 100Gr BT/ IMR 4064

cloverleaf

Handloader
Sep 10, 2006
4,382
1,017
Hey all- Have used this load for a long time. It is based on Dads old speer manual, (1964). Cant find any Nosler Data for this, closest is a 100 gr Speer. For taht Bullet I would be two full grains over Max. Here's the load:

RP Case - 250-3000 Savage
Primer - CCI 200
Bullet- 100 Gr BT
Powder- 35 Grains of IMR 4064

What does the Data look like for that load? Thanks for the effort. CL
 
GRT shows 57k psi at the nominal cartridge values.
Might be OK in a bolt gun, but wouldn't suggest it in a M99.

John
 
Code:
Cartridge          : .250 Savage
Bullet             : .257, 100, Nosler BalTip 25100
Useable Case Capaci: 38.913 grain H2O = 2.527 cm³
Cartridge O.A.L. L6: 2.515 inch = 63.88 mm
Barrel Length      : 24.0 inch = 609.6 mm
Powder             : IMR 4064

Predicted data by increasing and decreasing the given charge,
incremented in steps of 2.0% of nominal charge.
CAUTION: Figures exceed maximum and minimum recommended loads !

Step    Fill. Charge   Vel.  Energy   Pmax   Pmuz  Prop.Burnt B_Time
 %       %    Grains   fps   ft.lbs    psi    psi      %        ms

-20.0   83    28.00   2433    1314   30985   6481     90.5    1.440
-18.0   85    28.70   2490    1377   32973   6674     91.6    1.402
-16.0   87    29.40   2547    1440   35086   6862     92.6    1.365
-14.0   89    30.10   2604    1505   37333   7043     93.6    1.328
-12.0   91    30.80   2661    1572   39721   7217     94.5    1.290
-10.0   93    31.50   2717    1639   42261   7384     95.4    1.254
-08.0   95    32.20   2774    1708   44961   7542     96.2    1.219
-06.0   97    32.90   2830    1778   47835   7692     96.9    1.186  ! Near Maximum !
-04.0   99    33.60   2886    1850   50894   7832     97.5    1.153  ! Near Maximum !
-02.0  101    34.30   2942    1922   54153   7963     98.1    1.122  !DANGEROUS LOAD-DO NOT USE!
+00.0  103    35.00   2998    1995   57625   8083     98.6    1.092  !DANGEROUS LOAD-DO NOT USE!
+02.0  105    35.70   3053    2070   61329   8193     99.0    1.063  !DANGEROUS LOAD-DO NOT USE!
+04.0  107    36.40   3108    2145   65283   8291     99.4    1.034  !DANGEROUS LOAD-DO NOT USE!
+06.0  109    37.10   3163    2221   69508   8377     99.6    1.007  !DANGEROUS LOAD-DO NOT USE!
+08.0  112    37.80   3217    2299   74028   8450     99.8    0.981  !DANGEROUS LOAD-DO NOT USE!
+10.0  114    38.50   3272    2377   78868   8511    100.0    0.956  !DANGEROUS LOAD-DO NOT USE!

Results caused by ± 10% powder lot-to-lot burning rate variation using nominal charge
Data for burning rate increased by 10% relative to nominal value:
+Ba    103    35.00   3119    2160   67861   7878    100.0    1.020  !DANGEROUS LOAD-DO NOT USE!
Data for burning rate decreased by 10% relative to nominal value:
-Ba    103    35.00   2832    1780   47667   7918     93.4    1.185  ! Near Maximum !

You might be pushing the envelope, Troy.
 
Thanks Gentlemen- yup I think I'll back it off a ways and hope the accuracy stays there. I have had so much trouble with the "long headspace"in my Mauser. It has worked, but I think Ive got to back off a little to save on my brass. Antelope and Coyotes wont know the difference. Thanks again. CL
 
Last edited:
Back
Top