Reloading Dies

[truck driver]

Does anyone else have this problem with their Redding sizing dies? The threads are peeling off the body on my 35 Whelen sizing die.

 

[DrMike]

Never had that problem, Rodger. I would imagine that Redding would be prepared to make good on the die set, however, if you were to bring it to their attention. It doesn't look as if chasing the thread will do any good.

 

[SJB358]

Never seen it. Redding will do you right though...

 

[gerry]

I haven't seen it either I would send them in.

 

[Polaris]

Metallurgical manufacturing defect. Redding will make it right. Had a seating die crack when I dropped it on the concrete floor. Totally my fault, but they replaced it no question.

 

[JD338]

Call Redding stat.

JD338

 

[truck driver]

I sent them a message. The threads are gone, they just crumbled. I'm going to check my AI dies as well to see if I have the same problem with them.