anybody know what a starting point would be for rl33 and a 190 or 210 AccuBond? i hope that maybe rl33 would give me the same or better velocity as retumbo without the pressure spike surprises. :?
Data for the newer AccuBond bullets hasn't been released for QL. Here is some information using the 190 grain CC. There may be sufficient correlation to extrapolate a beginning load.
Cartridge : .30-378 Weath. Mag.
Bullet : .308, 190, Nosler CC HPBT 53412
Useable Case Capaci: 123.136 grain H2O = 7.995 cm³
Cartridge O.A.L. L6: 3.655 inch = 92.84 mm
Barrel Length : 26.0 inch = 660.4 mm
Powder : Alliant Reloder-33
Predicted data by increasing and decreasing the given charge,
incremented in steps of 2.0% of nominal charge.
CAUTION: Figures exceed maximum and minimum recommended loads !
Step Fill. Charge Vel. Energy Pmax Pmuz Prop.Burnt B_Time
% % Grains fps ft.lbs psi psi % ms
Results caused by ± 10% powder lot-to-lot burning rate variation using nominal charge
Data for burning rate increased by 10% relative to nominal value:
+Ba 93 116.00 3417 4925 76152 16535 100.0 1.194 !DANGEROUS LOAD-DO NOT USE!
Data for burning rate decreased by 10% relative to nominal value:
-Ba 93 116.00 3020 3848 48729 16880 94.9 1.461
Again, here is information for the 200 grain AccuBond. As previously stated, this may give you sufficient information to extrapolate a beginning load.
Cartridge : .30-378 Weath. Mag.
Bullet : .308, 200, Nosler AccuBond 54618
Useable Case Capaci: 119.202 grain H2O = 7.740 cm³
Cartridge O.A.L. L6: 3.655 inch = 92.84 mm
Barrel Length : 26.0 inch = 660.4 mm
Powder : Alliant Reloder-33
Predicted data by increasing and decreasing the given charge,
incremented in steps of 2.0% of nominal charge.
CAUTION: Figures exceed maximum and minimum recommended loads !
Step Fill. Charge Vel. Energy Pmax Pmuz Prop.Burnt B_Time
% % Grains fps ft.lbs psi psi % ms