Recent content by kiddekop

Magtech Solid Copper Ammunition is now on the CA Approved list for use in the condor zone.

I contacted Magtech to find out if they applied to the CA Dept of Fish & Game to get there solid copper hollow point ammo certified in California they said they have & are waiting for a response.Calibers:380,40sw,9mm,38spec,357mag,44mag,454casull,45acp & 500sw.

In the late 1970's I & a few friends shot a garand qualification match at the High Desert Rod & Gun Club Range in Yucca Valley,CA.We were shooting at 600 yard simulator targets from 100 yards standing ,kneeling or sitting & prone both in slow & rapid fire.We watched an elderly shooter fire all...

We checked into their optics since they're listed as a CA company but all of their optics are made in China so we decided to forget it. Bushnell has gone to the china source.

At least it's not the whole state just the political tree hugger imaginary condor home range.These birds don't land in brush or forested areas they have to have a clear area to land & a clear area to run to get airborne

I use imr 4831 and was told the max load is 71gr but I seldom if ever load to max .

30 cal 165gr E Tip

You can use FLITZ to clean dies.

165gr e tip in .308 best all around bullet for 30-06 plus others!

For cold weather(coolest was 40 below in november, most nights were -15) hunting trips in CO I switched to mag primers in my Sakos in 300wm & 30-06 ammo using IMR 4831 with 180gr sierra gamekings.I also used nosler solid base 165gr bullets.I have a friend who uses 165gr nosler solid base...

I bought one several years ago after having some chambering problem with some of my 300wm well used brass,took care of the problem.

165gr Nosler Solid Base,58gr IMR 4831,CCI LR Primer,Remington Case from 100yd bench put 5 shots in 7/16 inch from my Sako Finnbear , Acra Glass bedded with a Leupold 3x9x40 CPC reticle using Redfield rings and mount.This rifle was custom tuned & bedded by Master Gunsmith Ellis...

You're kidding the socialists control everything in this state they seldom have to leave office even when caught with their hands in the till.

A member of another forum bought a Tasco World Class Scope that he was using on the range recently when the adjuster broke off.Bushnell bought tasco when it was going belly up in 2002 all warantees were nulified.He sent it in to Bushnell & rec'd a reply about no warranty,scope no longer...

I read about Innovative Technologies belted magnum sizer die for my 300wm cases & contacted www.larrywillis.com and ordered one,works perfectly,I'm a satisfied customer.