Deep Creek Rock
Beginner
- Sep 22, 2012
- 5
- 0
Hi all,
I picked up an RCBS Hand Neck Turning Tool, and case holder. This is the model that is NOT attached to the case trimmer. It looks like this:
Im having issues getting it to work - I suspect the micrometer on it is bad. If I loosen the lock down screw for the cutter head, and turn the micrometer after zeroing it - the cutter does not move (and yes the spring is installed over the cutter shaft).
Is this normal for this tool, or am I doing something wrong ? I would think that the cutter head should move with the micrometer when turning it?
The instructions that came with it are kinda vague.
I picked up an RCBS Hand Neck Turning Tool, and case holder. This is the model that is NOT attached to the case trimmer. It looks like this:
Im having issues getting it to work - I suspect the micrometer on it is bad. If I loosen the lock down screw for the cutter head, and turn the micrometer after zeroing it - the cutter does not move (and yes the spring is installed over the cutter shaft).
Is this normal for this tool, or am I doing something wrong ? I would think that the cutter head should move with the micrometer when turning it?
The instructions that came with it are kinda vague.