truck driver
Ammo Smith
- Mar 11, 2013
- 7,395
- 1,066
I got to the range today to check my final zero for the 338Wm.
After the last session I had cleaned it down to bare metal because I had experienced pressure problems with some Swift bullets and needed to foul the barrel before I left foe MT.
Here's the target shot at 100yds with the poi set at 3" high.
As the barrel fouled the shots found the center of the target.
Shot #5 was shot unsupported standing with out a sling.
The small target dot is 1" in diameter and 3" above the sighting point.
There was no adjustment made to the scope and the shots moved into the center as the bore fouled.
All shots were with a cold barrel since it was 35* this mourning the barrel cooled quickly.
We also had our first frost here this mourning much means the start of the white tail mating season. :roll: :lol: :grin:
After the last session I had cleaned it down to bare metal because I had experienced pressure problems with some Swift bullets and needed to foul the barrel before I left foe MT.
Here's the target shot at 100yds with the poi set at 3" high.
As the barrel fouled the shots found the center of the target.
Shot #5 was shot unsupported standing with out a sling.
The small target dot is 1" in diameter and 3" above the sighting point.
There was no adjustment made to the scope and the shots moved into the center as the bore fouled.
All shots were with a cold barrel since it was 35* this mourning the barrel cooled quickly.
We also had our first frost here this mourning much means the start of the white tail mating season. :roll: :lol: :grin:
