NOSLER Suspect Load Data .25-06

[Quarter Round]

:?: On the Reload Bench forum http://www.reloadbench.com/ubb/Forum4/HTML/001045.html one of the posters noted the Nosler #5 manual has the same powder and weights for the 115 and 120 grain bullets. Some slight variations in the velocities, but weights are the same. This would also be the same data we are using for the 110 AccuBond.
Is this load data correct?

 

[Quarter Round]

BTT
Hoping someone will respond.

 

[JD338]

Quarter Round,

You can use the 115 gr loading data for the 110 gr AB. Just remenber to start low and work up, watching for pressure signs.

Rergards,

JD338

 

[Quarter Round]

JD338, When looking at the load data for 115 and 120 gr. bullets we noted the data was the same except for changes in speed and a couple of powder variations. When this data is applied to the 110 gr. AB you are using the load data for the 120 gr. bullets. So essentially Nosler could say use the load data for the 120 gr. bullets when loading the 110 gr. AB. It just seemed strange.

As always. Start low and work up, watching for pressure signs.