So this morning I finally got to work on some 7-08 factory seconds brass that I had gotten from SPS. Brass did not look bad at all. I attempted to run all pieces through a neck sizing die and one piece of brass would not fit in the shell holder. I closely examined the brass and it is definitely too big to fit in the shell holder and thus not usable. I know when buying factory seconds the quality is not going to be superb but has anyone experienced anything like this with SPS product?
SPS brass that is not useable
- Thread starter ReloadKy
- Start date
RL338
Handloader
- Mar 23, 2017
- 3,272
- 5,290
Peterson brass has been an issue with my Hornady shell holder. As far as SPS #2 brass the only issue I found was with 7mm Rem Mag , 1 piece was all scratch up and the other 49 fine. When I mean scratch up , it was like someone chucked it up in a drill and used 80 grit sandpaper.
