wisconsinteacher
Handloader
- Dec 2, 2010
- 1,976
- 290
I just set the head space and torqued the barrel nut on the action. I used a go and no-go gauge. The go gauge allows the bolt to close with a little pressure but is smooth while the no-go gauge allows the bolt to close 1/4 of the entire throw. I used a torque wrench and put 32 ft/lbs on the nut. I figure if I add the length of the nut wrench, I am close to 35 ft/lbs on the nut. I have check with both gauges about 10 times each and I get the same results every time. I dropped some virgin brass in and they close with ease. I think I did it right. Does it sound right to you?