reloader 26 in 25-06

muzz

Handloader
Nov 11, 2014
265
12
What do you think about the reloader 26 in the 25-06?

Can someone run me a ql for rl26 115 ballistic tip and 110 AccuBond 24" barrel?
 
Cartridge : .25-06 Rem.
Bullet : .257, 115, Nosler BalTip 25115
Useable Case Capaci: 60.107 grain H2O = 3.903 cm³
Cartridge O.A.L. L6: 3.250 inch = 82.55 mm
Barrel Length : 24.0 inch = 609.6 mm
Powder : Alliant Reloder-26

Predicted data by increasing and decreasing the given charge,
incremented in steps of 2.0% of nominal charge.
CAUTION: Figures exceed maximum and minimum recommended loads !

Step Fill. Charge Vel. Energy Pmax Pmuz Prop.Burnt B_Time
% % Grains fps ft.lbs psi psi % ms

-20.0 80 47.36 2579 1699 30650 11427 95.0 1.545
-18.0 81 48.54 2650 1793 32949 11761 96.3 1.504
-16.0 83 49.73 2721 1890 35436 12066 97.4 1.465
-14.0 85 50.91 2792 1990 38129 12341 98.3 1.421
-12.0 87 52.10 2862 2091 41044 12582 99.0 1.372
-10.0 89 53.28 2932 2195 44208 12787 99.5 1.326
-08.0 91 54.46 3001 2300 47645 12955 99.9 1.280
-06.0 93 55.65 3070 2407 51380 13083 100.0 1.237
-04.0 95 56.83 3138 2514 55430 13183 100.0 1.196
-02.0 97 58.02 3205 2623 59783 13276 100.0 1.156 ! Near Maximum !
+00.0 99 59.20 3271 2733 64483 13366 100.0 1.117 ! Near Maximum !
+02.0 101 60.38 3337 2843 69565 13450 100.0 1.080 !DANGEROUS LOAD-DO NOT USE!
+04.0 103 61.57 3402 2956 75068 13529 100.0 1.045 !DANGEROUS LOAD-DO NOT USE!
+06.0 105 62.75 3467 3069 81035 13602 100.0 1.011 !DANGEROUS LOAD-DO NOT USE!
+08.0 107 63.94 3531 3184 87515 13670 100.0 0.978 !DANGEROUS LOAD-DO NOT USE!
+10.0 109 65.12 3595 3301 94567 13731 100.0 0.946 !DANGEROUS LOAD-DO NOT USE!

Results caused by ± 10% powder lot-to-lot burning rate variation using nominal charge
Data for burning rate increased by 10% relative to nominal value:
+Ba 99 59.20 3408 2966 80611 12836 100.0 1.022 !DANGEROUS LOAD-DO NOT USE!
Data for burning rate decreased by 10% relative to nominal value:
-Ba 99 59.20 3059 2390 49510 13870 98.6 1.246

Cartridge : .25-06 Rem.
Bullet : .257, 110, Nosler AccuBond 53742
Useable Case Capaci: 60.236 grain H2O = 3.911 cm³
Cartridge O.A.L. L6: 3.250 inch = 82.55 mm
Barrel Length : 24.0 inch = 609.6 mm
Powder : Alliant Reloder-26

Predicted data by increasing and decreasing the given charge,
incremented in steps of 2.0% of nominal charge.
CAUTION: Figures exceed maximum and minimum recommended loads !

Step Fill. Charge Vel. Energy Pmax Pmuz Prop.Burnt B_Time
% % Grains fps ft.lbs psi psi % ms

-20.0 80 47.92 2617 1673 30357 11372 94.1 1.522
-18.0 82 49.12 2690 1767 32643 11719 95.5 1.482
-16.0 84 50.32 2763 1864 35121 12039 96.7 1.442
-14.0 86 51.51 2836 1964 37803 12329 97.7 1.400
-12.0 88 52.71 2909 2066 40713 12586 98.6 1.352
-10.0 90 53.91 2981 2171 43872 12807 99.2 1.305
-08.0 92 55.11 3053 2277 47304 12991 99.7 1.260
-06.0 94 56.31 3124 2384 51040 13135 99.9 1.217
-04.0 96 57.50 3195 2493 55110 13238 100.0 1.176
-02.0 98 58.70 3265 2604 59530 13325 100.0 1.136 ! Near Maximum !
+00.0 100 59.90 3334 2715 64296 13407 100.0 1.098 ! Near Maximum !
+02.0 102 61.10 3402 2827 69459 13484 100.0 1.061 !DANGEROUS LOAD-DO NOT USE!
+04.0 104 62.30 3470 2941 75061 13556 100.0 1.025 !DANGEROUS LOAD-DO NOT USE!
+06.0 106 63.49 3537 3056 81147 13623 100.0 0.992 !DANGEROUS LOAD-DO NOT USE!
+08.0 108 64.69 3604 3172 87773 13683 100.0 0.959 !DANGEROUS LOAD-DO NOT USE!
+10.0 110 65.89 3670 3291 94998 13737 100.0 0.927 !DANGEROUS LOAD-DO NOT USE!

Results caused by ± 10% powder lot-to-lot burning rate variation using nominal charge
Data for burning rate increased by 10% relative to nominal value:
+Ba 100 59.90 3478 2954 80639 12861 100.0 1.003 !DANGEROUS LOAD-DO NOT USE!
Data for burning rate decreased by 10% relative to nominal value:
-Ba 100 59.90 3111 2363 49383 13849 98.2 1.225
 
I think Retumbo is a better powder for the combo you listed. I've worked up 115 partitions to over 3200 FPS without problems in a 24" barrel. Accuracy wasn't there, but it was predicted safe by QL and Nosler if I remember correctly.
 
Thank you dr. For the ql info.

I really like this powder in my 280ai and would like to see if it will work in my 25-06. Plus keep it simple with same powders for a few rifles.
 
That looks real good in the 25-06... Might have to break the 25-06 out and give it a shot.. Man, 3200+ with the 115's is pretty good..
 
Back
Top